RC4WD 1/14 6x6 Sledge Hammer Heavy Haul Off-Road Hydraulic RTR Dump Truck

Englische Beschreibung:

1/14 6x6 Sledge Hammer Heavy Haul Off-Road Hydraulic RTR Dump Truck

Specifications:
Hard Plastic European Style Front Cab
Full Metal 2 Speed Transmission (Planetary Gears)
Transfer Case (Billet Aluminum)
Scale Fuel Tank (Billet Aluminum)
Super Scaled Leaf Spring Suspension Setup
Scale Rims (Billet Aluminum)
Remote Lockable Rear Axle (Locking Differential)
Full Metal Front and Rear Axle Housing
Steel Scale Drive Shaft
Realistic Front Cab Latch
Retractable Steel Ladder
Molded Functional Fuel Tank
Fully Controllable Truck Bed
Automatic Trailer Gate (Do Not Attempt to Open by Hand)
Rear Light Guard (Protects Against Rocks)
Scale Light Buckets (Fits 3-5mm LED)
Recommended Payload: 15kg / 33lbs
Maximum Load: 25kg / 55lbs
LiPo Cutoff
Fully Painted
Scale Wheel/Tire
Cylinder Maximum Thrust: 109kg / 231lbs
Brushed Driven Motor
300KV Brushless Motor-Driven Micro Hydraulic Pump
Length: 26.5in / 674mm
Width: 8.93in / 227mm
Height: 10.7in / 273mm (Including Antenna)
Weight: 10kg / 22lbs
Axle Gear Ratio: 2.6:1
Transfer Case Gear Ratio: 1:1
First Gear 1:64, Second Gear 1:16 (Transmission)
Basic 6 Channel 2.4Ghz Radio
This Product Is Professionally Pre-assembled
Manufactured by JDCustoms
30 Days Limited Warranty

What's Included:
1x 1/14 6x6 Sledge Hammer Heavy Haul Off-Road Hydraulic RTR Dump Truck

Required Parts:
5000mAh 11.1V 50C 3S1P LiPo Battery Pack with XT60 Plug (Battery size must be no bigger than 140mm in length, 45mm in width, and 25mm in height)
Compatible Battery Charger
4x AA Batteries for Radio (Z-S1718)
Chevron AW ISO 32 Hydraulic Oil 14oz (Z-X0042)

Notes:
Must turn on the transmitter before starting the ESC.
ESC Supports XT60 Connector
While some components may come assembled, it may be in your best interests to check the products to ensure all hardware is tight. In some cases, you may want to apply threadlock to some of the hardware that was already installed.
Use good quality hex drivers to avoid stripping screw heads.
Use thread lock when putting metal screws into metal parts.
Use threadlock sparingly.
Do not over tighten screws, otherwise, you may strip the thread.
Do not use more than 3S battery. (11.1 volt(s))
This product is for experienced R/C users. Not recommended if you just started with R/C.